12'x20'x4' inground pool vinyl liner replacement

[kathylu]

Hi everyone...not sure if this will be a double post...if so sorry about that. Just sending an update, the liner is ordered and hopefully being manufactured this week. As I mentioned, I sent a sample of the old liner bead and my salesman said it was a standard bead. I need to do a lot of prep work before this liner can go in...removing the old liner, sanding and spray painting the walls as well as filling in holes and leveling the sand bottom. I have 2 more questions for you awesome pool folk...how far in advance can I start this prep-work (I anticipate receiving the liner in 10 days or so) and is there any special sand I need to get for the floor? I'm assuming children's sandbox type sand because there are no pebbles etc. Thank you for this wonderful and informative site! Kath

[waste]

Hey Kath!

You can address the wall issues at any time, sand them down and Rustolium *TM* spray paint them, to keep the rust at bay. I'd wait until the liner is delivered to fix the floor, any rain or strong winds will effect the floor, so you want to only have to retrowel it once, just prior to putting the liner in. I can give some tips on retrowling sand, but it will take me some time to type it and I'm not sure when my next day off is.

I wouldn't use 'play sand' it's too expensive - go to a building supply place or quarry and get 'dead sand' or 'mason's sand' @ ~ $.10/ pound. You can use 5 gallon buckets or the plastic tote bins to put it in. If you need a lot of sand, you can line a pickup truck bed with plastic and have them use a bobcat to toss a scoop in the back (a bobcat scoop is ~ 2000 lbs.).

[kathylu]

Hi everyone Tomorrow is the big day...wallls are sanded, rust-free and spraypainted, coping repainted and sand added to the floor. My first liner installation tomorrow. Wish me luck! Thank you for this forum...awesome! Kath

[Watermom]

Hope you'll find 2 minutes to report in! Good luck.