I fixed my AG skimmer...with JB Weld

[Poconos]

Here's another way that I've used successfully in the past. Take a flat file and square off the joint that's leaking. Take a piece of the same diameter pipe and cut a ring then slice it to make a collar. You can heat it with boiling water if you want for a better fit. Use primer and a good amount of glue. Slip the collar against the pipe joint and put a hose clamp on it until the glue sets for a few hours or preferrably overnight. If you need a complete 360 seal cut another piece to fill the gap and glue all at the same time. Make sure that all surfaces that butt are as square as possible.
Al
Attachment 179
(ajs-1)