No power light

[gohogs1]

Just got my pump back working and when I first got my cell going the power light and generating light came on then they both went out the display stays on, I dumped 5 bags of salt in but still no power light. Pool size is 12 by 32 and 8 foot on the deep end. The pump has not been working since December and I have not added any salt since October. Any suggestions?

[Poolsean]

What system do you have?
Have you checked your power to the power supply (make sure you have voltage going to it)?
Have you checked the internal fuses (most systems have a main fuse protection)?

[gohogs1]

It's a Hayward aquarite with a t-9 cell. Power to the board is good fuse is good and the thermistor is good. I think it was damaged when my timer caused the voltage to drop. That was what was causing my pump to overheat.

[kirkdbjl]

I had the same proble and the mother board had gone out. You will probably need to replace the mother board if yu haven't already