Newbie to Forum...Looking for help

[PoolDoc]

You reported 2 sets of numbers:

alkalinity - 71 ppm
Hardness - 110 ppm

TA 90
CH 190

Both are on the low end of things. They are not too low, with a pH of 7.8, but they are too low for a concrete pool, if the pH is 7.2. I don't trust the pool store readings, but I've learned to be cautious about test results the first few times someone uses a K2006.

So, I want to you to keep the pH low enough so that we know for sure it's not REALLY 8.8, and then look at things again.

[fairfieldmania]

ok, I added the muriatic acid Tuesday night...I winged the amount....I also added a pound of CYA on Tuesday night...I don't feel it is fully dissolved...as I see a bump in my DE filter pressure, but it hasn't come back down....and then added two bags of cal-hypo last night....readings this morning:

FC 8.8
CC 0.4
pH 7.8
Alk 100
CH 200
CYA still didn't register, although it did seem a little cloudier based on memory from the first test
Sat Index 0.5
Water Temp 80

Suggestions???

[Watermom]

How does your water look? I'd suggest using cal-hypo a little while longer to bring your calcium hardness reading up some. Did you and Ben ever agree on the volume of the pool? Either way -- you have a large volume pool and the best I can tell from a quick scan through this long thread is that you have added 3 lbs. of CYA and used a few pucks. Is that right? You're gonna need to get some CYA in there or it is going to be a pain in the rear to keep chlorine in this pool.

Did you fill in the pool chart like Ben asked you to do back in post #7? I looked in the chart, but unless I missed it, I didn't find your info. If you haven't done so, please add it. It helps people be better able to advise you.

[fairfieldmania]

pool is perfect...great color...clean....

i have some left over bags of calcium hardness from the pool store..that I can throw in...sounds like you are saying to take care of that first? before solving low TA and high pH...

I've thrown in the following up to now after I previously had the pool drained and acid washed....3 lbs of CYA...10 lbs of alk...19 lbs of hardness...and then several pucks and bags of cal-hypo...

no, we never agreed on the size...i actually found the original drawing for the pool in my files...how do I provide that info?? it only shows l, w, and d

I did fill out the pool chart...i rushed the numbers in and the later posted correct numbers..not sure if any moderator updated my information...

forgive me for being blunt...but I am still searching for the answer of how do I bring up my ALK without bringing down the pH? That is the answer I am looking for and the main reason I have joined this forum...it's been almost two weeks and that is the one answer I am looking for...I know have my proper test kit and much better understanding of pool issues in reading through the forum, so many thanks for that...but I'm trying to figure out how the relationship of low TA and high pH....which one do i take care of first...how much should I put in...how long do I wait to take care of the other parameter...that type of guidance.....

Also, I clearly am not a spammer...I am a dedicated pool owner who respectfully has posted on this site....does the approval process by a moderator still need to be in place??...i believe that is one of the reasons...almost two weeks have passed....obviously waiting for the taylor kit coming in the mail is the other...

thanks ahead of time