Check/Clean Cell problem on Pool Pilot.

[320Driver]

Hello everyone;

New to the pool business (just got a brand new pool), we decided to go with the Pool Pilot. After a rather long wait for the builder to install the unit, we finally got the DIG-220 and SC-36 last week. The builder said we had to wait a minimun of 30 days before installing it because the finish had to cure first. Alright then... I come back from work one day and there it is! But, the "Check/Clean Cell" is on the display and the red light flashes about two thirds of the time it operates. We run the pump around 8 hours a day.

Since my pool builder whom I'll call "Big Bird's Eye" is absolutely no help, I resorted to discussing the matter with some of the locals, someone suggested I test the salt level and compare it to the unit reading. And it was off bid a lot, the strip showed about 3600ppm. So I went into the Maintenance menu and matched the level with the strip test. The light desappeared but only temporarely.

I run the Pool Pilot at 50%, my pool temp is around 82F. So if any of you has a comment or suggestion please let me know.

Thanks in advance.

320Driver

[PatL34]

Moderator,

Please remove this thread as it was answered previously. The member reposted it as he seemed to have problems posting the first one.

Thanks.

Pat

[320Driver]

How do you delete a thread?

320Driver