+ Reply to Thread
Results 1 to 3 of 3

Thread: Newbie pump/sand filter AIR question

Hybrid View

  1. #1
    Poconos is offline SuperMod Emeritus Whizbang Spinner Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars
    Join Date
    Dec 1969
    Location
    Honesdale PA
    Posts
    1,802

    Default Re: Newbie pump/sand filter AIR question

    There is no air bleed on that filter. It's a smaller version of my S-244T. If you look at the manual, the center pipe from the laterals is a loose fit to the valve assembly and that's where any trapped air would escape. Sounds like you may just have a low water level and are sucking air from the skimmer on a cyclic basis. For now I'd just try raising the water level an inch or so and see if the situation changes. With good flow the trapped air in the pump strainer basket should purge itself.
    Al

  2. #2
    Join Date
    May 2006
    Location
    Downingtown, PA
    Posts
    192

    Default Re: Newbie pump/sand filter AIR question

    I know when I get that 'vortex' in my skimmer when starting up it means my debris basket in my pump needs to be cleaned.
    Outside of Philadelphia, PA
    18' x 40' IG - 22K gallons
    Sylvan Gunite Pool (1979)
    Plaster re-done (1997)
    48 Sq Ft Hayward D.E. Filter (2003)
    1.5 hp Hayward Super Pump (2006)

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts