.
I think Watermom actually answered that question. It might have gotten missed with the TA recommendation. You asked:
Her reply was:
(How you didn't have algae with a FC that low, I don't know! You have some luck!)
Did you have any other questions?
.
I think Watermom actually answered that question. It might have gotten missed with the TA recommendation. You asked:
Her reply was:
(How you didn't have algae with a FC that low, I don't know! You have some luck!)
Did you have any other questions?
Last edited by FormerBromineUser; 10-18-2014 at 07:46 PM.
26K gal 20x40 rectangular IG vinyl pool; Apr 2014: New pump, liner, auto-cover, & water; Pentair Whisperflo 1HP pump; Pentair Trition sand filter; Cover/Star CS-500 auto cover; Taylor K-2006C; OTO
I guess I'm all set. Since I wasn't clear in my OP that I was not trying to clear up algae, and since Watermom's sticky is addressing algae, I wanted to make sure I had it right. I was looking for clarification between "it won't hurt" and "it is recommended." I'll just bring it up to around 25ppm (496 oz of 8.25% bleach!) and be done with it. Thanks all.
Sharkline Escalade RTR 24' x 54" Round AGP; OptiFlo 2-speed pump; Pentair PLM-100 Cartridge Filter; Hayward 250FDN Heater; Taylor K-2006; AquaIlluminator Return
Perfect! Yea, sometimes things get combobbled on threads. Good luck!
A piece of advice, open early. When you think the water temperature may be close to 60 degrees, open. Take a full set of readings and post them. We will especially want to see your new CYA reading.
You are not a subscriber, so unless you update that, you may have to wait for an answer on recommendations. If so, raise your FC right away and use your best judgement on the rest. Better yet, become a subscriber! You can go to the settings tab, then my account, then subscriptions. A minimum of 14 bucks gets you priority attention.
26K gal 20x40 rectangular IG vinyl pool; Apr 2014: New pump, liner, auto-cover, & water; Pentair Whisperflo 1HP pump; Pentair Trition sand filter; Cover/Star CS-500 auto cover; Taylor K-2006C; OTO
Okay, I opened the pool yesterday. Here are the readings:
FC: 3.2 ppm
CC: 0 ppm
pH: 7.8
TA: 120 ppm
CH: 60 ppm
CYA: 45 ppm
The CYA is down mostly to the fact that I had about a 50% water loss over the winter (heavy snow & ice load) and replaced with tap water.
Sharkline Escalade RTR 24' x 54" Round AGP; OptiFlo 2-speed pump; Pentair PLM-100 Cartridge Filter; Hayward 250FDN Heater; Taylor K-2006; AquaIlluminator Return
How does the water look?
26K gal 20x40 rectangular IG vinyl pool; Apr 2014: New pump, liner, auto-cover, & water; Pentair Whisperflo 1HP pump; Pentair Trition sand filter; Cover/Star CS-500 auto cover; Taylor K-2006C; OTO
It looks crystal clear! No signs of algae or anything.
Sharkline Escalade RTR 24' x 54" Round AGP; OptiFlo 2-speed pump; Pentair PLM-100 Cartridge Filter; Hayward 250FDN Heater; Taylor K-2006; AquaIlluminator Return
Excellent. May I assume you raised that FC to the high-end of your FC/CYA ratio? Like about 6?
Last edited by FormerBromineUser; 05-25-2015 at 11:29 PM.
26K gal 20x40 rectangular IG vinyl pool; Apr 2014: New pump, liner, auto-cover, & water; Pentair Whisperflo 1HP pump; Pentair Trition sand filter; Cover/Star CS-500 auto cover; Taylor K-2006C; OTO