Calculating optimal pump size for my system?

[mas985]

Do you have a spa, water features or a vacuum style cleaner that requires high HP?

If not, you could probably go down to a 3/4 HP full rated high efficiency pump. If you do, then you might consider a two speed pump (1 HP full rated or 1.5 HP uprated).

[Phillbo]

no spa but I do have a Hayward Pool Vac like this .. http://www.intheswim.com/Automatic-P...erby-Hayward-/

[mas985]

3/4 HP may be enough if you have a dedicated vacuum line and valves to isolate it into the pump. I cannot say for sure. However, you may want to stick with a 1 HP full rated two speed. In the end, you may save more energy with the 2 speed anyway since you can run it on low most of the time and on high only when vacuuming.

Too learn more about pump sizing, check here:

http://poolplaza.com/pool-pump-sizing-2.shtml
http://www.poolspa.com/publications/...ries/pumps.htm

[Phillbo]

I live in Arizona.. my hayward runs when the pump is on. currently it's an after thought and is plugged in to the skimmer. THe pool has pop up heads on the bottom that do not work worth a darn. During the replaster I am having a decicated suction line run so it will draw through the skimmer while the hayward runs as well.

I'm not sure what to do with the pop ups in the bottom. Too expensive to run a bunch of return lines so most likely they will stay.

[mas985]

Didn't know about the floor cleaners. That changes the situation somewhat if you want to use them. You will need pretty high flow which will lead you toward a higher HP pump. You need to find out what flow is required for each cleaner and make sure the pump can supply the total. I would lean more towards a 2-speed pump so that you can have the high speed for cleaning and low speed for general circulation.