When you get it off, rub it between your fingers, if it feels slimy it is algae, if it feels gritty, it's not. You can rub a crushed vitamin C tablet, or some ph down on it - if it disappears, then it is from metals.
When you get it off, rub it between your fingers, if it feels slimy it is algae, if it feels gritty, it's not. You can rub a crushed vitamin C tablet, or some ph down on it - if it disappears, then it is from metals.
Northeast PA
16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5
I just read a post by Waterbear about iron stains and salt. My builder used Morton table salt-550 lbs of it. Would that have any effect? The bags, as I recall, said 99.6% pure. Could that also cause what looks like rusting of screws in the water? My builder came by and replaced some screws but cleaned off some with pH down and left me the bag for future leaning.
It is not slimy, but gritty.
How do I get rid of the metals in the pool if that is the cause?
You can use ascorbic acid (vitaminC). Bring your ph down to 7.2, crush some vitamin C tablets and put them in a sock. Rub them on the stains, the stains should go away. If you have a lot of stains you may want to purchase some ascorbic acid. Add some sequeserant, such as jack's magic, or metal free, or sequasol something that says it will get metal out. Sometimes just adding some sequesterant along with bringing down your ph, the stains will go away.
Northeast PA
16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5
I tried cleaning the skimmer box and stairs with cal hypo and some pH down. Cal hypo really didn't do much of anything. pH down did a good job on some and OK on other stains, but really didn't do anything on the stairs.
I'll try some vit. C and see what happens. My pH was up,added muriatic acid and brought it down to 7.4 last night.
Thanks for the information!
Table salt should NEVER be used in a pool. It contains an anti-caking agent (yellow prussiate of soda) which is a iron compound. Only use pool salt, solar salt, or water softener pellets that don't contain iron removers or water softener tank cleaners that are at least 99.5% pure salt!
Retired pool store and commercial pool maintenance guy.
It was the builder that added the salt. They told me I'd probably see these little satins and not to worry about them. My steps now have a large amountof these little specks all over them.
What should I use to get the metals out? I saw Jack's Blue stuff-I have a SWG and a heater, the purple stuff is not for heaters as I recall. Is there a better formula out there and what is the proper way to do it? I really don't trust the pool stores to know.
one other thing-when trying the vit. C does the strength matter? I used 250 mg. tabs and results were OK, but better than with cal hypo. Do I need stronger tabs?
Last edited by poolbee; 07-12-2006 at 08:57 PM.
If the vitamin C tablet worked, then it is metal stain. If the cal hypo worked, then it is an organic stain. If it is a metal stain, you can either use ascorbic acid (which is vitamin C), or oxallic acid. I use the ascorbic. Since you only have a few spots, I would try lowering the ph down to 7.2 and adding a sequestering agent like sequasol, jack's magic the pink stuff, or blue stuff, Metal free, any thing that say holds metals in suspension. Try this first - sometimes it will lift off stains that have just started. If it doesn't work, you can then do the ascorbic acid. You can get it at:
http://www.msm-msm.com/store/agora.c...scorbic%20Acid
or:http://www.chemistrystore.com/Ascorbic_Acid.htm
Northeast PA
16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5
I would be interesed in where you got the info on the Purple Stuff?Originally Posted by poolbee
Retired pool store and commercial pool maintenance guy.