We have an Asahi 21x41x52 Oval bracless going up this week/weekend, and the instruction manual is written in bad translated Japanese - (open end is inside pool, take off excess tape after fill the water completely )
We can figure it out, but would love some input from the experts.

So here is our plan of attack:
1: build Side stuctures
2: dig holes, use patio block to level brace top at ground level
3: attach tension straps
4: temporaly put top seat on to check for level
5: pile sand inside pool area
6: put wall and liner inside pool area
7: lay rails - put a patio block under each non-braced joint - I think I need to dig holes for these as well
8: Install wall
9: place cove (we do have the preformed foam ones)
10: level sand
11: Install skimmer
12: Install liner
13: Install top rail and upper joint
14: Assemble verticals
15: Assemble top seats
16: Install seat covers
17: fill pool
18: get drunk

Any suggestions or insider tips to make this go smoothly??

THANKS!!!!