Jim,

I don't think there is any problem with you running at the lower alkalinity of 50. The main reason to have higher TA would be to prevent pH swings, but you are seeing less of that (due to less CO2 outgassing) so no problem there. You are technically in a more corrosive pool water balance state which normally means either increasing CH or pH to adjust for that, but I think you are fine so long as you don't plan on running at a low pH (much less than 7.4). This only applies to a plaster/gunite pool situation. If you are concerned, you can post a full set of numbers and I can be more specific.

Richard