SWG..before or after large heater

[duraleigh]

Hi, Sean,

Thanks. The reason for my post is this is a REALLY big heat exchanger and, while it is not yet running, I am calculating 20+ farenheit temp changes. Still no issues?

Dave

[Davenj]

I have an autopilot system. Would it be feasible to move the sensor section between the filter and heater. Replace the sensor section with a piece of pipe and leave the cell after the heater. Just a thought.
You would have to be carefull not to turn off or reduce the flow thru the cell. Since the flow sensor would not be at the cell.

Dave

[Poolsean]

20 degree split on any heater, regardless of heat exchanger size, means insufficient flow through the heater. This can lead to premature damage. Other areas of concern if this is a heat pump is the evaporator coil. Any blockage around the coil will cause inefficiencies and higher temp splits.

splitting the tri-sensor from the manifold....hmmm too risky. All you need is for the cell to be scaled and the tri-sensor to not detect this condition (blockage of flow) and you can have a read disaster. "Don't do it" is my 2 cents, besides, it voids warranty.