+ Reply to Thread
Results 1 to 2 of 2

Thread: Super Pump II Wiring Question

  1. 03-30-2007 12:19 AM #1
    JWB
    JWB is offline ** No working email address ** JWB 0
    Join Date
    Dec 2004
    Location
    Upland, CA.
    Posts
    35

    Default Super Pump II Wiring Question

    Hi,

    I'm exchanging an old single-speed pump with a new Hayward SP II two-speed model. The original pump was connected using three 115V wires (green, red and white). So far I've adjusted the SP II's black plug for 115V operation and connected the green wire to ground.

    On the SP II, I have a L1 spade and a L2 spade. I assume these refer to high & low speeds and only ONE should be hooked up. However, with two remaining wires, which of these (red or white) should I connect?
    Does it matter?

    Thanks...
    Reply With Quote Reply With Quote
  2. 04-01-2007 09:41 AM #2
    JWB
    JWB is offline ** No working email address ** JWB 0
    Join Date
    Dec 2004
    Location
    Upland, CA.
    Posts
    35

    Default Re: Super Pump II Wiring Question

    Gosh 1 for 4 on this forum...

    The answer is both wires (neutral and hot) needed to be connected... if anyone's interested.
    Reply With Quote Reply With Quote
+ Reply to Thread
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules