My DE filter works fine for like 10 min and then the pressure goes up

[fog80]

ok bad situation is even worse now.

i was vacuuming to waste today and making good progress because I was emptying the filter basket like every 5 minutes.

However towards the end i started losing suction and now i have a pretty serious clog in my skimmer line. I tried to force it through with a garden hose and that didnt work. Then i tried using a stick and it sort of pushed the clog down even further.

when i turn the other skimmer on and run the filter the clogged filter doesnt do anything. but when i close the other skimmer the clogged skimmer will work (but very slowly)


what should i do?

[ivyleager]

You could use a pipe snake, like plumbers use. I'll bet you can rent one for the day. Home depot would have one, but unless you think you'll be using it more than once, then not worth the $$.

I've always vacuumed to waste without taking out the skimmer basket. That way nothing gets into the pipes. Is yours set up that way?

Good luck.

CaryB
(The Cup stays state-side!)

[fog80]

You could use a pipe snake, like plumbers use. I'll bet you can rent one for the day. Home depot would have one, but unless you think you'll be using it more than once, then not worth the $$.

I've always vacuumed to waste without taking out the skimmer basket. That way nothing gets into the pipes. Is yours set up that way?

Good luck.

CaryB
(The Cup stays state-side!)

I wish I could have done it that way, but I have to take the skimmer basket out and put the hose directly into the hole. All leaves get trapped in the pump basket. I was filling up that basket every 7-10 minutes!

Last night I went to home depot to try the bladder thing I saw mentioned on this forum. However the thing like busted inside the skimmer and didnt remove the clog. I then took a super long drill bit and slowly tried to break away the clog in the skimmer and it seems to have done something because its not "squishy" anymore when I poke it with the bit. However I cant tell where the 90 degree turn is so I think i got the trash that was in the "straightaway" part of the pipe, but theres got to me more in the 90 degree elbow.

Today I think I am going to have to cut the skimmer line from the pump side (where it sticks out of the ground) and try either a snake or another one of the bladder things to force the clog out of the line.

Any other suggestions?

[fog80]

does anyone know if a product like this works:

http://www.homedepot.com/webapp/wcs/...cStoreNum=8125

If I cut the pvc skimmer pipe at the pump and shot this co2 cartridge would it remove the clog in the skimmer line?

or am i better off trying the drain king from the pump side into the skimmer line? I tried the bladder thing in the skimmer itself last night and it busted (the bladder)

i was also thinking about getting a snake from the rental place on my way home.

what should i do?

[anotherpyr]

I go with a snake. They make a hand snake but I can't find it listed on the Home Depot or Lowes websites.

To prevent the problem in the future, I'd recommend using a leaf canister with the pool vacuum. The fact that it saved me from having to empty the basket in the pump all the time made it worth it. It'll need a 3'-4' section of hose in order to hook it up.