Leaking Pump - Help Pleas

[markphin]

Al,
I think you might be right. What I am struggling with is getting that impeller off as it spins both ways. I don't see the flat on the back end of the motor shaft you are referring to. Do I have to take something else apart?
I attached a link to the schematic of my pump as reference. One thing I did notice, is that when I took off the locking nut, I did not notice and o-ring or difuser (items 7 and 9 on the schematic). Not sure if they could have come off previously and I didn't notcie or do they come off when you take off the impeller (which is what I am currently struggling with.
Your continued help is greatly appreciated. I really don't want to pay a pool guy $100 bucks for a 10 minute fix.
Thanks
Mark

http://www.a1poolparts.com/-strse-17...ent/Detail.bok

[Poconos]

That pump is definitely way different than mine but it's item #2 that is probably bad.
Check this site and see if the owners manual is listed. Didn't see anything for an Ultra-Flow. The flat for a wrench on mine is at the rear under the back cover. One manual I looked at on the site below mentioned a screwdriver slot to hold the shaft. See what you can find.

http://www.pentairpool.com/techinfo/...3.php?d=2&s=42

[markphin]

Would this area to hold the shaft be withn the motor itself or the pump?

[Poconos]

Typically the back end of the motor, the end opposite the pump end. Under that back cover there is usually the centrifugal starter switch and in some cases the starting capacitor.
Al

[markphin]

Al,
Thanks very much for the help. The seal was the problem. Replaced it myself for $20. Probably saved at least $100. What a great forum. Has saved me tons over the years.
Thanks Again.

[Poconos]

You're very welcome. I like it when the solution is cheap and relatively easy.
Al