Algae...pool store test results

[SoCalBoo]

so the pump has been on for about 14 hours, 6 of those hours through the solar. I put in the amount of bleach per poolmom's recommendation, and slowly added Ph throughout yesterday afternoon and evening at the return - used almost a gallon. Actually ended up overshooting the Ph a tad, but not too bad - Ph is 7.2 consistently in three areas of the pool and the spa this morning. Ch is at least 15 (I don't have a scientific method to test...my drop test stops at 5ppm, so I just put 1/3 pool water and 2/3 distilled water, and it is registering above the 5ppm sample). Interesting, TA only went down to 110 from 120. For the amount of acid I added, I would have expected a drop of about 25ppm (by my calculations for my size pool, it would take 48 oz to drop it 10ppm. Oh well, 110 is just fine by me.

I unplugged the trisensor.

So how long should I keep the cl level at 15ppm?

When is the pool safe to swim in...is it safe to swim at 15ppm of cl?

thanks for the help. things are looking better, but the proof will be in the pudding - or, actually, the absense of the mustard colored pudding on the side of my pool!

[SoCalBoo]

(bump)

After keeping ch level at or about 15 for a number of days, I held off on adding more chlorine yesterday, and the mustard returned. I was brushing at least once a day, ph was good (7.4-7.6). oh well. Ch is still registering about 12/13ppm (I don't have the most accurate method of testing...yet...just bought Ben's kit).

Figure it is time for poly. bought some poly today, the 60% strength. back of container says 11-17 oz per 10k of pool. I have 22,500g in ground, gunite and plaster. So that's 25-38 oz (container is 32 oz). Should I just put whole thing in there? Any problem with adding poly with pool with ch levels in low teens?

Thanks for the help. I'll cut and paste this over to the algae forum.