Pool Pilot Low Amps Cell 0V 0.6A

[vgg659]

Thanks for your help, Sean.

A couple of clarifying points regarding my original post.
1. After checking my salt levels with test strips, my salt is 4200ppm. I have recalibrated the Pool Pilot Digital, but my problem hasn't changed.
2. I am getting the warning light and message "Low Amps - Cell".

>> What do the center and two outer blades look like compared to the blades between them? Are they all the same length or are the leading edges shorter?

The center blades are shorter by 1.25mm and 2mm (top and bottom), and the outer blades are ~0mm and 1mm (top) and 1mm and 1mm (bottom). These center and outer blades wear are even, but the coloration is slightly darker (grey vs silver) compared to the other blades.

>> What % are you running?

Presently 75% @ 89F.

>>Do you see the cell cycling ON and OFF, as per the display on the lower right corner.

Yes, it is cycling.

>> How do you have your DIG running? Controlling the main filter pump, connected to an Electronic Control System, or wired to an external time clock?
The Pool Pilot Digital is controlling my two speed pump. The Pool Pilot Digital is connected to an external timer.

>> Put the unit in Boost and let it run for a few minutes before doing the TEST POOL PILOT.

No change - 0V and 0.6A with warning light and message.

>> Press the PUMP button and let me know what it reads.

High or Low.