Newbie to pools

[mthandt]

Thank you Janet! I have been reading tons of stuff and I think I've got the idea. Just realy have no faith in the kits that I am using because I'm not really sure how old they are. I have been using a Taylor K-2006 and a K-2005 but some of the tests just don't seem to work right. Do you know which of the reagents would lose there punch after sitting around for awhile? They were stored in a garage here in Florida for idk how long. Think for now I am just gonna go to the store tomorrow and have them test some water and give me the numbers. I might try to drain the pool and refill a little bit at a time to lower the CYA levels. I realize this won't be as effective as one quick half a drain but I don't wan the Gf's parents to think I'm crazy for draining the pool the first week on the job, haha! All they know is the pool looks clean now so why would I be draining it.

[PoolDoc]

Echoing what Janet said, I'd encourage you to look at the Best Guess chart and page, at least for now. You can always drain later. But change as little as you have to, while you're learning to operate the pool

Good luck!

[aylad]

What Ben said!!

I personally run a high CYA pool intentionally because in our climate (Louisiana) I use less chlorine and it's much easier to keep my levels stable. I would imagine in Florida your climate is very similar, so lowering your CYA may not be the best thing to do, especially if your water is in good sbape now.

I would replace any reagents that were in a garage longer than one year. They can last a lot longer than that when stored in a cool dry place, but heat can make them degrade. You can order them from several places online, but I usually get mine from sps-poolspas.com. Their prices are among the lowest and their service is fast.

Janet

[mthandt]

Thanks again! The CYA part of the test kit seems to be working at least because the store tested the same. Good to know that that CYA level isn't that excessive for down south here then. It seems like right now the pool is using virtually no chlorine because the CYA is high, it's been cool out and the pool is partially shaded. It's only at about 5 ppm though and according to the best guess chart I guess that's a little low. Trying to decide if I should bump it up a couple ppm and just keep it there. The pool seems to be doing well right now but I figure a little more can't hurt.

[Watermom]

The pool is using little chlorine because the water is cold, but when the weather starts to warm up, if you don't run higher cl levels you'll have a green pool! We see it all the time. Since your CYA is 80-90, then you don't want to use any stabilized forms of chlorine. So stay away from trichlor pucks and dichlor powder. What kind of pool is this -- gunnite, vinyl, fiberglass? Also, go ahead and post a full set of current water testing results.

[mthandt]

The pool is using little chlorine because the water is cold, but when the weather starts to warm up, if you don't run higher cl levels you'll have a green pool! We see it all the time. Since your CYA is 80-90, then you don't want to use any stabilized forms of chlorine. So stay away from trichlor pucks and dichlor powder. What kind of pool is this -- gunnite, vinyl, fiberglass? Also, go ahead and post a full set of current water testing results.

Yeah, the CYA level is my biggest fear with the trichlor pucks which is what I would most likely be using. I would like to do the BBB method but again I think my girlfriends parents would think I am crazy if I was out there pouring a gallon of chlorine in the pool everyday. I think they would feel better with me just using the pucks. Next time they leave town I'll just drain half the pool, haha. I think for now I'm just gonna continue using the pucks and monitor the CYA levels and if it starts to get too high and the chlorine demand becomes to great I'll consider swapping out some of the water or switching to liquid chlorine.

Here are the results from the store test:

TC: 5 ppm
FC: 5 ppm
CC: 0 ppm
pH: 7.6
TA: 100 ppm
Calcium: 250 ppm
CYA: 80 ppm

Oh, and it's a screened in gunite pool.

[Watermom]

Your numbers all look ok except that your chlorine is bit low for your CYA level.

Regarding continuing to use the pucks ---- it is your call. If it were my pool with a CYA of 80-90, I would not use them. It is easy to get into trouble when your CYA level gets too high. Just my opinion.

Glad to have you on the forum!