Intex Ultra Frame 18 x 48 Pool

[slick6]

Yes I did use the SSSR. I added 4 doses of bleach, 20 Mule, and CYA this evening. Going to check the numbers again in the morning.

[Watermom]

How much CYA did you add? How did you add it?

Borax raises Ph. So, with a pH of 7.8, you shouldn't have added the Borax.

[slick6]

I added 4 doses of CYA. According to recipe the Borax and CYA is 1 to 1. Right?

[Watermom]

4 doses of chlorine or 4 doses of CYA? What was the product name and ingredients of what you added?

You only add the 1 to 1 doses of Borax if you are using dichlor because it is acidic and will drive the pH down. The Borax is to counteract this drop in pH.

I'm not sure that you understand the recipe. There are directions there for using bleach for a few days until you can buy the needed Dichlor. At that point, you stop using bleach and use dichlor until your CYA (stabilizer) is around 50ppm. Then, stop the dichor and switch back to bleach.

[slick6]

i used the CYA recommended from Sam's Club. Pool Brand I think. The one recommended on the recipe. I'll get another reading this afternoon. Post it here if that is ok

[Watermom]

That isn't CYA. It is Dichlor which is chlorine with CYA in it.

Test your pH again this evening before you add more dichlor. If your pH is above 7.3 or so, don't add Borax.

[slick6]

Here are my current readings:
Cl-5
Br-10
pH-7.5
Alk-200
Hard-90
How should I proceed this evening ?
Thanks
I have not added salt yet. I didn't test CYA because my understanding is that it takes a few days.