+ Reply to Thread
Results 1 to 10 of 17

Thread: pump hums

Hybrid View

  1. #1
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,244

    Default Re: pump hums

    Quote Originally Posted by Poconos View Post
    Then again, some people say I'm a packrat and never replace anything unless I have to.
    Al

    YA THINK???? You forgot to tell the part about not only will you never replace anything unless it is totally dead, but then you want to keep all the old useless dead stuff around the house, too!!!!
    Last edited by Watermom; 05-28-2008 at 11:03 AM.

  2. #2
    Join Date
    May 2006
    Posts
    128

    Default Re: pump hums-new question

    i have a heater and i noticed a leak from the screw that is underneath the pipe that goes to the heater. this screw is what i have to unscrew when i close for the winter. i did tighten it when i opened it but there is a drip. i put a small pail underneath it last night and this evening the pail is full. when i emptied the pail i also noticed the water was warm to touch. i do not have the heater going yet so i couldn't figure why the water was so warm. then i noticed the pump motor was hot to touch...i have never noticed the motor being hot before, but i never really have ever touched it...is that normal? i shut the pump off and i could hear a hissing. i put my finger underneath this screw and the hissing stopped. can you give me advise about the leak and if that is normal about the pump motor. thanks

  3. #3
    Poconos is offline SuperMod Emeritus Whizbang Spinner Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars Poconos 4 stars
    Join Date
    Dec 1969
    Location
    Honesdale PA
    Posts
    1,802

    Default Re: pump hums

    That drain plug is easy. Take it out and wrap about 10 turns of teflon pipe tape on the threads and screw it back in. Tighten until the leaking stops and be careful not to overtighten. As for the motor, they do run hot especially if in direct sun. Think I remember 140F or so on mine with an IR thermometer and that's inside a poolhouse. Could the water just feel warm because the air was cool? Only way a pump could heat water significantly is for the flow to be almost blocked and pumping only a trickle then all thre energy from the motor goes into heating water rather than moving it.
    Al

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts