+ Reply to Thread
Results 1 to 10 of 40

Thread: Hopefully...minor clarity issue

Hybrid View

  1. #1
    Join Date
    May 2010
    Location
    Midwest
    Posts
    29

    Default Re: Hopefully...minor clarity issue

    Ran through a full set of tests, checked filter and pressure is slowly climbing, up to 20 now, brushed the floor and walls. Not doing anything else till morning, then likely only chlorine. Keeping pool open tonight. I think that I will close it tomorrow as we're expecting a bright sunny day.?

    Scores:
    FC-25
    TC-25
    CC-0
    PH-7.4
    TA-200
    CH-130



    Only this forum may understand this next piece. Laid down at the skimmer with a flashlight and just watched for a bit...actually kind of relaxing...except for the crud in the water.

    Noticed a powdery like substance on the water surface in the skimmer. First thought was pollen but with the cover pretty much always on there shouldn't be all that much. Next thought is that the chlorine is working and it is the algae coming out...? Also notice along the skimmer wall a "build up" line of this stuff...a very slight yellow color with possibly hint of green (green is very faint, could be caused by lighting).


    One other question. When might I get out of purgatory and be able to post without getting approval?

  2. #2
    Join Date
    May 2010
    Location
    Midwest
    Posts
    29

    Default Re: Hopefully...minor clarity issue

    This morning Update.

    Tested CL measured +/-25. Looks like its held so far.

    Water was "lightly" coming out of returns so checked filter, up to 25 from 20. Recharged and dropped to 18 and the return water was back up to normal velocity.

    With lighting changes couldn't tell if the water was clearer. Can easily see bottom of shallow end but not deep end (about the same as lst night).

    This morning, planning on closing cover and waiting. Will check filter and Chlorine when I get home this evening.

    Home stretch?
    18X36 IG 26,000 gal., vinyl, 9' deep end, Hayward 1hp Superpump, Hayward EC65 Filter, Raypak 200k BTU Heater, Power Cover.

  3. #3
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,344

    Default Re: Hopefully...minor clarity issue

    You probably shouldn't close the cover with cl level that high. The fumes may damage your cover.

    Hope you are in the home stretch. Keep an eye on your filter pressure, backwash as needed. You might want to try using some skimmer socks.

    I assume you are now just using bleach and no more cal-hypo?

  4. #4
    Join Date
    May 2010
    Location
    Midwest
    Posts
    29

    Default Re: Hopefully...minor clarity issue

    Home for lunch opened pool, checked chlorine holding around 25. Filter holding at 19. Water seems to be clearing though can't see the return at the bottom...again lighting makes it hard to tell.
    18X36 IG 26,000 gal., vinyl, 9' deep end, Hayward 1hp Superpump, Hayward EC65 Filter, Raypak 200k BTU Heater, Power Cover.

  5. #5
    Join Date
    May 2010
    Location
    Midwest
    Posts
    29

    Default Re: Hopefully...minor clarity issue

    Couple more things.
    Have had skimmer socks on for a week or so now. Really like them. Also, just saw the bottom. Barely, but it's there.

    I haven't added anything since the 3 gal of bleach but the plan is yes to continue with bleach. I have a little Cal-hypo left so may try to use it up at some point.
    18X36 IG 26,000 gal., vinyl, 9' deep end, Hayward 1hp Superpump, Hayward EC65 Filter, Raypak 200k BTU Heater, Power Cover.

  6. #6
    Join Date
    May 2010
    Location
    Midwest
    Posts
    29

    Default Re: Hopefully...minor clarity issue

    Water is clearing, can see the bottom even after sweeping. However, the best I can describe it the water looks "thick".

    Was out of town this evening so wife tested and chlorine had dropped. added 1.5 gal of 6%. Chlorine back up. pressure in filter slightly above 20.

    At this point I think I'm going to go easy on additional chlorine and let it fall to around 10 then try to maintain and watch the water. Let me know if you have any additional thoughts. Will also clean the socks tomorrow.
    18X36 IG 26,000 gal., vinyl, 9' deep end, Hayward 1hp Superpump, Hayward EC65 Filter, Raypak 200k BTU Heater, Power Cover.

  7. #7
    Join Date
    May 2010
    Location
    Midwest
    Posts
    29

    Default Re: Hopefully...minor clarity issue

    This morning's update

    Skimmer socks cleaned
    Filter pressure 21
    Vacuumed the floor and walls
    Pool open
    Raining

    Numbers
    FC-25
    TC-25
    CC-0
    Ph-7.4
    TA-210
    CH-140

    Numbers seem to be climbing a little? Why?

    Questions
    1) Best way to stay ahead of Chlorine draw?
    2) How best to clean crud from within the skimmer walls (they're black, sticky and oily).
    3) How best to go about the various adjustments for my numbers:
    a) Lower TA by about half
    b) Lower CYA by about half
    c) Lower Chlorine by a little over half
    I've read the forum and understand the aeration/low ph process for TA, the drain and fill for CYA, seems to be keep the pool open for Cl. However, looking for a systematic process to work through all these without sending everything amuck....
    18X36 IG 26,000 gal., vinyl, 9' deep end, Hayward 1hp Superpump, Hayward EC65 Filter, Raypak 200k BTU Heater, Power Cover.

+ Reply to Thread

Similar Threads

  1. pool clarity
    By MANEH in forum Using Chlorine and Chlorinating Chemicals
    Replies: 5
    Last Post: 08-23-2012, 07:42 PM
  2. minor plaster repair waterline tiles
    By FPICOL in forum In-Ground Pool Construction and Repair
    Replies: 1
    Last Post: 06-23-2010, 09:47 PM
  3. Water Clarity - Need Education
    By szampino in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 1
    Last Post: 06-11-2008, 12:15 PM
  4. Minor liner problem
    By topnotch in forum In-Ground Pool Construction and Repair
    Replies: 0
    Last Post: 08-03-2006, 09:37 PM
  5. Water clarity problem
    By keastman in forum Dealing with Algae & Slime
    Replies: 15
    Last Post: 05-03-2006, 04:21 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts