+ Reply to Thread
Results 1 to 9 of 9

Thread: High TA

Hybrid View

  1. #1
    Join Date
    May 2012
    Location
    Oklahoma
    Posts
    4

    Default Re: High TA

    I have not added any Chlorine yet, my pool supply store recommended getting my TA & PH in check before I add anything else. My PH is around 7.2 and my TA is around 200. I am using the test strips that came with my pool. I am planning on going to my local pool store to pick up a better test kit later today. I do have Shock, Chlorine tabs and conditioner that I can use. I would really like to use the pool before the holiday weekend is up!!!

  2. #2
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,293

    Default Re: High TA

    Quote Originally Posted by smaloney62 View Post
    I have not added any Chlorine yet, my pool supply store recommended getting my TA & PH in check before I add anything else.
    Wrong, wrong, wrong! Your pool is likely to turn green first. And THEN, they will be able to sell you chemicals by the wheelbarrow!

    Do NOT listen to them!

    1. Forget about TA for now.
    2. Your pH is fine, for now.
    3. A 30' AG pool is as much as 21,000 gallons. Each gallon of bleach adds about 3 ppm FC (free chlorine) to your pool. Add 4 gallons (or (5) 96oz jugs) ASAP.
    4. See if you can get the HTH 6-way kit at your Walmart (check availability)
    5. Otherwise, get a cheap OTO / phenol red kit.
    6. If you do NOT get a 6-way, get your pool store to check your CYA level -- but IGNORE their dumb chemical advice!!
    7. Read the muriatic page linked in my signature.
    8. Then, use muriatic acid to hold your pH below 7.4. Do NOT worry about TA; it will take care of itself IF you do the other stuff.
    9. You do NOT need added calcium hardness: if your pool store tells to add some, IGNORE THEM.
    10. Tell us what your pool water LOOKS and SMELLS like.
    11. Use the link in my signature to get to YOUR signature setting: put your pool info there: gallons, type, make / model of pump / filter, other equipment.

  3. #3
    Join Date
    May 2012
    Location
    Oklahoma
    Posts
    4

    Default Re: High TA

    My pool holds 24,500 gallons. I have a 1b bag of shock, should I add it now? While my wife is on her way to get the bleach.
    30' AG pool

  4. #4
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,293

    Default Re: High TA

    Quote Originally Posted by smaloney62 View Post
    My pool holds 24,500 gallons.
    Actually -- unless you have a dished bottom -- it's not that much. Dealers and mfgs almost always quote pools at the running over the sides level, not at the actual water level. 21,000 gallons is a close estimate for a 52" sidewall pool. If you have a 48" sidewall pool, it will be less.

    You can use the bag of shock.

  5. #5
    Join Date
    May 2012
    Location
    Oklahoma
    Posts
    4

    Default Re: High TA

    My pool has 54" side walls. I added 4 gallons of bleach + the shock.
    How long should I wait before we can get in the pool?
    I was hoping we could get in the pool before long.
    30' AG pool

  6. #6
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,253

    Default Re: High TA

    You can get in it now. Your chlorine may be a little high but since this is a fresh fill with no CYA to speak of yet (other than the little bit that was in the bag of shock), the chlorine level isn't going to stay high. You might not want to wear your brand new swim suits, though.
    Last edited by Watermom; 05-28-2012 at 07:28 PM. Reason: fix typo

  7. #7
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,293

    Default Re: High TA

    Quote Originally Posted by smaloney62 View Post
    My pool has 54" side walls.
    OK. 21,500 gallons.


    Quote Originally Posted by Watermom View Post
    You might not want to wear your brand new swim suits, though.
    High chlorine, especially if stabilizer is not high, is MUCH harder on swimwear than it is on people.

+ Reply to Thread

Similar Threads

  1. Advice Needed - High CYA, High Nitrates, and Lots of Algae
    By capshockeyfan in forum Pool Chemicals & Pool Water Problems
    Replies: 19
    Last Post: 07-03-2012, 05:47 PM
  2. High amounts of DPD Powder needed!! To high or no Clorine?
    By KaseyNewman in forum Testing and Adjusting Pool Water Chemistry
    Replies: 3
    Last Post: 01-16-2012, 11:52 PM
  3. High Phosphates > 1,000 & High Nitrates 90ppm
    By applepar in forum Salt Generators (SWCG) & other Chlorine Feeders
    Replies: 21
    Last Post: 06-23-2011, 05:49 PM
  4. had algae, PH high, TA high, water now cloudy
    By Mom4fun in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 6
    Last Post: 06-12-2011, 01:09 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts